Snake Plant Propagation Problems and Solutions

snake plant propagation

Snake plant is a popular houseplant that is easy to grow and propagate. However, there are some common problems that can occur when propagating the plant.

One of the most common problems with propagating the snake plant is that it will not root. Another problem with propagating the snake plant is that it will rot at the stem before it has rooted. These can all happen as a result of having too much or too little water.

The best way to avoid this problem is by using a potting mix with good drainage and by watering the cutting just enough so that it doesn’t dry out but doesn’t have excess water sitting in the bottom of the pot either.

Sunlight, Sunlight, Sunlight

Snake plant needs a lot of sunlight when propagating. It should be placed in an area that gets at least 6 hours of direct sunlight per day. The most common sign that your snake plant is not receiving enough sunlight is when its leaves start turning yellow.


The most common pest problem when propagating snake plants is mealybugs. These pests are small and white, and they secrete a waxy substance that makes them hard to see. They also feed on the leaves of the plant, which can cause yellowing or browning of the leaves.

The best way to avoid pests is to use clean potting soil and wash your hands when dealing with your snake plant.

If you notice any signs of these pests on your plants, the best way to get rid of them is by using a cotton swab dipped in rubbing alcohol or an insecticidal soap spray.

Best way to Propagate Snake Plant

The best way to propagate snake plants is by taking a cutting from the mother plant.

The cutting should be taken from the stem of the plant, preferably in the spring or summer. The cutting should be at least six inches long and have at least two leaves on it.

The cut end of the stem should be dipped in rooting hormone powder and then planted in a pot with moist soil.


No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *